rilpoint_mw113

Hálózat

(Változatok közti eltérés)
Admin (vitalap | szerkesztései)
(Új oldal, tartalma: „Router: 2801 NM-ESW-161 Munkaállomások: * 192.168.1.10/24, GW: 192.168.1.1 * 192.168.2.10/24, GW: 192.168.2.1 Switch> Switch>ena Switch#conf term Enter configuration c…”)
Újabb szerkesztés →

A lap 2019. május 2., 12:21-kori változata

Router: 2801 NM-ESW-161

Munkaállomások:

  • 192.168.1.10/24, GW: 192.168.1.1
  • 192.168.2.10/24, GW: 192.168.2.1

Switch> Switch>ena Switch#conf term Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#enable password pass1 Switch(config)#enable secret pass2 Switch(config)#banner motd # Enter TEXT message. End with the character '#'. Hello, ez a teszt router

Switch(config)#hostname router-1 router-1(config)#exit router-1(config)#exit

Press RETURN to get started.

Hello, ez a teszt router

router-1>enable Password: <pass2>

router-1#sh int FastEthernet0/1 is down, line protocol is down (disabled)

 Hardware is Lance, address is 0060.3ee9.7601 (bia 0060.3ee9.7601)
BW 100000 Kbit, DLY 1000 usec,
    reliability 255/255, txload 1/255, rxload 1/255
 Encapsulation ARPA, loopback not set
 Keepalive set (10 sec)
 Half-duplex, 100Mb/s
 input flow-control is off, output flow-control is off
 ARP type: ARPA, ARP Timeout 04:00:00
 Last input 00:00:08, output 00:00:05, output hang never
 Last clearing of "show interface" counters never
 Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
 Queueing strategy: fifo
 Output queue :0/40 (size/max)
 5 minute input rate 0 bits/sec, 0 packets/sec
 5 minute output rate 0 bits/sec, 0 packets/sec
    956 packets input, 193351 bytes, 0 no buffer
    Received 956 broadcasts, 0 runts, 0 giants, 0 throttles
    0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
    0 watchdog, 0 multicast, 0 pause input
    0 input packets with dribble condition detected
    2357 packets output, 263570 bytes, 0 underruns
    0 output errors, 0 collisions, 10 interface resets
    0 babbles, 0 late collision, 0 deferred
    0 lost carrier, 0 no carrier
    0 output buffer failures, 0 output buffers swapped out

router-1#conf term Enter configuration commands, one per line. End with CNTL/Z. router-1(config)#int fa0/0 router-1(config-if)#ip address 192.168.1.1 255.255.255.0 router-1(config-if)#no shutdown router-1(config-if)#description Telephely router-1(config-if)#exit

router-1(config)#int fa0/1 router-1(config-if)#ip address 192.168.2.1 255.255.255.0 router-1(config-if)#no sh router-1(config-if)#description Iroda router-1(config-if)#exit

router-1(config)#exit router-1#sh ip int brief Interface IP-Address OK? Method Status Protocol FastEthernet0/0 192.168.1.1 YES manual up up FastEthernet0/1 192.168.2.1 YES manual up up Vlan1 unassigned YES unset administratively down down router-1#

(gép pingeljen)

router-1#conf term Enter configuration commands, one per line. End with CNTL/Z. router-1(config)#ip route 192.168.1.0 255.255.255.0 FastEthernet0/0 router-1(config)#ip route 192.168.2.0 255.255.255.0 FastEthernet0/1 router-1(config-if)#exit

router-1>sh ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP

      D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
      N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
      E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
      i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
      * - candidate default, U - per-user static route, o - ODR
      P - periodic downloaded static route

Gateway of last resort is not set

C 192.168.1.0/24 is directly connected, FastEthernet0/0 C 192.168.2.0/24 is directly connected, FastEthernet0/1


R1>ena Password: R1# sh run

R1#copy run sta Destination filename [startup-config]? Building configuration... [OK] R1# R1#reload Proceed with reload? [confirm]

Skin by RIL Partner